Advertisement
Use the + and – buttons to make your selection, then press Enter to confirm the setting.
Setting Printing Position Adjustment: Up/Down (0–9) (Code 02)
This step is optional during initial set up. This setting can be changed later if you find that
the printing alignment is off. If the alignment is incorrect, you can adjust the position on the
time card where the punches will print. When the code "02" appears, set the position (up/
down) where the punch will print. Use the + and – buttons to make your selection, then
press Enter to confirm the setting.
NOTE: Default settings recommended.
Setting Printing Position Adjustment: Right/Left (0–9) (Code 03)
This step is optional during initial set up. This setting can be changed later if you find that
the printing alignment is off. If the alignment is incorrect, you can adjust the position on
the time card where the punches will print. When the code "03" appears, set the position
(right/left) where the punch will print. Use the + and – buttons to make your selection, then
press Enter to confirm the setting.
NOTE: Default setting recommended.
HN3—ALARM OPTIONS
The HN Series Time Clock accommodates up to 12 alarms. You can set up alarms to signal
the beginning and end of shifts and breaks. At the designated time, the time clock will play
the internal alarm music or ring an external bell, which is purchased separately.
19
Advertisement
