Table of Contents
Advertisement
3e–525A–3 Wireless Access Point
Monitoring
In the upper right-hand corner of the Wireless Bridge — General
screen there is a button called Monitoring. f you click on this button, a
pop-up window will appear (WDS Information). If you select Enable ref-
esh, you can set the bridge refresh interval from 5 seconds to 30 minutes.
Refreshing the screen allows you to see the effect of aiming the antenna to
improve signal strength.
Wireless Bridge — Radio
The Wireless Bridge — Radio screen contains wireless bridging
information including the channel number, Tx rate, Tx power, spanning
tree protocol (802.1d) enable/disable, and remote AP's BSSID. This page
is important in setting up your bridge configuration.
29000167-001 B
Chapter 5: Wireless Bridge Configuration
83
Advertisement
Table of Contents
