Table of Contents
Advertisement
3e–525A–3 Wireless Access Point
Rogue AP Detection
The Wireless Access Point — Rogue AP Detection screen allows the
network administrator to set up rogue AP detection. Enable rogue AP
detection and enter the MAC Address of each AP in the network that you
want the AP being configured to accept as a trusted AP. (You may add
up to 20 APs.) Enter an email address for notification of any rogue or
non-trusted APs. (The MAC Address for the 3e–525A–3 is located on the
System Configuration — General screen. You can also select the follow-
ing filter options.
• SSID FIlter: Check the SSID option to only send rogue APs that
match the AP's SSID or wireless bridge's SSID.
• Channel Filter: Check the channel filter option to only send rogue
APs that match the AP's channel or the wireless bridge's channel.
• If both options are checked, only APs that match both the SSID
and channel are sent.
The Adjacent AP list, under Monitoring/Reports on the navigation
menu, will detail any marauding APs.
42
Chapter 3: Access Point Configuration
29000167-001 B
Advertisement
Table of Contents
