1
1. Driving position
Insert the screw strip through the screw guide. Then
reaches the position next to the driving position.
Removing screw strip
of the arrow.
If you depress the reverse button, you can pull out the
screw strip in the reverse direction of the arrow.
1
1. Reverse button
1. Extension handle
Use of extension handle allows you to drive screws into
OPERATION
Driving operation
Switch on the tool by pressing the switch trigger and
at the same time pushing the lock button. Hold the tool
squarely against the workpiece and apply forward pres-
sure to the tool. The screw will be automatically carried
to the driving position and driven into the workpiece.
CAUTION:
•
Always hold the tool squarely against the driving
surface. Holding it at an angle may damage the
screw heads and cause wear on the bit. This
may also lead to poor fastening.
surface until the driving is over. Failure to do so
•
Be careful not to drive a screw onto another
screw already fastened.
•
Do not operate the tool without screws. It will
damage the driving surface.
6 ENGLISH
1