Table of Contents
Advertisement
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1
2
1. Casing 2. Thumb screws
Press the dust cover toward the plane bearing and pull
out the bit. If the dust cover cannot be moved as far
as the plane bearing, try it again after turning the bit
slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
1
2
3
1. Plane bearing 2. Dust cover 3. Bit
1
1. Lever 2. Stopper base 3. Plate 4. Casing
There are 3 positive-lock screw length settings. To
obtain the desired setting, pull out the stopper base
while depressing the lever until you see the number of
the desired screw length (indicated on the plate) appear
to rest on the very top edge of the casing.
See the table below for the relation between the number
indicated on the plate and the respective screw length
ranges.
Number indicated on the plate
Depress the stopper base as far as it will go. While
knob in the B direction.
5mm
1
2
1. Stopper base 2. Casing 3.
Installing screw strip
2
3
1. Feeder box 2. Screw strip 3. Screw guide
4
5 ENGLISH
Screw length range (mm)
25/28
32
40
3
2
3
25 - 28
28 - 35
35 - 41
-
A
B
1
Advertisement
Table of Contents
