Driving Operation - Makita DFR452 Instruction Manual

OPERATION

Driving operation

NOTICE:
Always check the driver bit carefully
for wear before driving operations. Replace a worn
driver bit or poor fastening may result.
NOTICE:
Always hold the tool squarely against
the driving surface. Holding it at an angle may dam-
age the screw heads and cause wear on the driver
bit. This may also lead to poor fastening.
NOTICE:
Always keep the tool firmly against the
driving surface until the driving is over. Failure to
do so may cause insufficient fastening of screws.
NOTICE:
Be careful not to drive a screw onto
another screw already fastened.
NOTICE:
Do not operate the tool without screws.
It will damage the driving surface.
NOTICE:
If the feeder box does not work
smoothly when driving screws, spray car wax
(spray type) on the sliding surfaces. Never lubri-
cate it.
Switch on the tool by pulling the switch trigger. Hold the
tool squarely and firmly up against the driving surface. A
screw will be automatically carried to the driving posi-
tion and fastened.
Fig.17
Driving operation in push drive
mode
1. Pull the switch trigger slightly and release it. Then
quickly press the mode select button.
The indicator lamp on the push drive mode selector
lights up, and push drive mode becomes activated.
Fig.18
► 1. Mode select button 2. Indicator lamp
2.
Depress the lock button while pulling the switch
trigger, and then release the switch trigger.
Fig.19
► 1. Lock button 2. Switch trigger
NOTE: While selecting push drive mode and locking
the trigger on, the motor does not rotate under no
load to minimize power consumption.
3. Hold the tool squarely against the driving surface
and apply forward pressure to the tool.
The screw will be automatically carried to the driving
position and driven at full speed.
Fig.20
10 ENGLISH
2
2
1
1