Removing The Rechargeable Battery - Remington F9200 User Manuals

CLEANING
To ensure long lasting performance clean after each use.
1. Ensure the shaver is switched off.
2. Grasp the shaver head on each side and pull it upwards (FIG B).
3. Tap out any excess hair shavings.
4. Rinse the cutters (underneath the shaving head) and the shaving head itself under
warm running water (FIG C).
5. Refit the shaving head once it is dry.
REPLACING FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils
and cutters are replaced every 12 months. Signs that the foils and cutters need replacing
are:
Irritation - you may experience skin irritation.
Pulling - your shave may not feel as close and you may feel the cutter pulling your hair.
To replace the foils and cutters:
1. Ensure the shaver is switched off.
2. Grasp the shaver head on each side and pull it upwards. Discard the shaver head (FIG D).
3. Grasp the cutters as shown and pull upwards. Discard the cutters (FIG E).
4. Snap the new cutters into the holders (FIG F).
5. Replace the new shaving head (FIG G).

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled
correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the shaver until it
stops.
2. Use an appropriate tool to prise off the front cover trim (FIG H) at the points
indicated (ut).
3. Prise off the rear part of the handle (FIG I).
4. Prise off the remaining front part of the handle (FIG J).
5. Remove the three screws then unclip the circuit board cover (FIG K)
6. Lift out the circuit board and turn it over. Cut the two wires (FIG L).
7. Cut the fixings at each end of the battery using an appropriate tool (FIG M).
7