Remington F9200 User Manuals page 5

PARTS
1. Display
2. On/off switch
3. Pop-up intercept trimmer
4. Hair pocket
5. Foil
6. Intercept trimmer
CHARGING
Charge the shaver:
• Before using for the first time.
• When only one indicator light (t) is showing.
• After your shaver has not been used for a long time.
1. Ensure the shaver is switched off.
2. Connect the charging adapter to the charging stand and then to the mains power
outlet.
3. Place the shaver into the charging stand (FIG A). The charging adapter can also be
connected directly to the shaver.
4. Charge for two hours.
5. During charging, the indicator lights (t) will show the level of charge. All three
lights will flash for a time and then go out when the shaver is fully charged.
6. During use, the indicator lights will go out one at a time to show the level of charge
remaining.
Quick charge
The quick charge feature allows you to charge your shaver for five minutes if the battery
is flat. This will give you five minutes of use (enough for one shave) at the normal motor
speed (without using the turbo mode).
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your facial hair and skin to become accustomed to the new shaving system.
1. Switch the shaver on by pressing the on/off switch.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Use short linear strokes.
• Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
7. Foil
8. Head lock button
9. Charging stand
10. Charging adapter (not shown)
11. Cleaning brush (not shown)
5