Removing The Rechargeable Battery - Remington R3600 Manual

Rotary shaver
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you
clean your appliance after each use.
Ensure the appliance is switched off and unplugged from the mains before cleaning.
1.
Open the shaver head by pressing the release button (Fig. A).
2.
Empty out any hair clippings.
3.
Pull the shaver head upwards to remove it from the body (Fig. B).
4.
Locate the centre arrow and slide the retainer in the opposite direction to release it.
Once released, lift it out of the shaver head (Fig. C). Make a note of the correct
orientation of the retainer to make refitting easier.
5.
Carefully brush away any hairs from the cutters.
6.
For a more thorough cleaning, lift out the three cutters (Fig. D).
7.
Wash the shaving head under running water (Fig. E). Allow to dry thoroughly.
8.
Carefully refit the three cutters.
9.
Refit the retainer. Locate the centre arrow and slide the retainer in the same direction
as the arrow until it clicks into place (Fig. F).
10. Once the shaver head is assembled, align the spring hinge with the slot at the back of
the hair pocket and press into place (Fig. G). Snap the head assembly closed.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
The rechargeable battery must be removed from the appliance before it is scrapped.
Disconnect the charging adapter before removing the battery.
1.
Run the shaver until the motor stops.
2.
Unplug the shaver.
3.
Unscrew the 2 screws on rear housing (one is located under the trimmer).
4.
Pry off the rear housing and expose the battery.
5.
Lift the battery carrier and circuit board out of the shaver body then cut the tabs
holding the batteries to the circuit board.
Used batteries must be removed from the appliance and disposed of at an appropriate
official recycling/collection point.
Do not attempt to operate the shaver once you have opened it.
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Style series

Table of Contents