Appendix 1 - Signal Names - Quarch Technology Torridon HS Technical Manual

Appendix 1 - Signal Names

The following signal names are used to specify a single signal or a group of signals. These may be
used in commands that take a parameter "SIGNAL_NAME". Note that some commands, such as
those returning a value, only accept a parameter that resolves to a single signal. In this case you
cannot use the group names
Signals
3V3_POWER
3V3_CHARGE
5V_POWER
5V_CHARGE
12V_POWER
12V_CHARGE
SPECIAL1
Signal Groups
ALL (Allows change of all signals at the same time)
Revision 1.0
Torridon HS Lite Drive Control Module - Technical Manual
(MATED on GND)
©Quarch Technology Page 28 of 28