Quarch Technology Torridon HS Technical Manual page 19

Clear the terminal window and displays the normal start screen. Also runs the internal self test.
The same action can be performed by pressing return on a blank line.
*IDN?
Displays a standard set of information, identifying the device. An example return is shown below
Family: Torridon System
Name: Ethernet Cable Pull Module
Part#: QTL1271-01
Processor: QTL1159-01,3.50
Bootloader: QTL1170-01,1.00
FPGA 1: 1.0
*TST?
Runs a set of standard tests to confirm the device is operating correctly, these tests are also
performed at start up. Returns 'OK' or 'FAIL' followed by a list of errors that occurred, each on a
new line.
CONFig:MODE BOOT
Configures the card for boot loader mode (to update the firmware), requires an update utility on
the PC.
CONFig:MESSages [SHORt|USER]
CONFig:MESSages?
Gets or sets the mode for messages that are returned to the user's terminal
Short: Only a "FAIL" or "OK" will be returned
User: Full error messages are returned to the user on failure
CONFig:TERMinal USER
Sets the terminal response mode to the default 'User' setting. This is intended for use with
HyperTerminal or similar and manually typed commands
CONFig:TERMinal SCRIPT
Sets the terminal response mode for easier parsing. Especially useful from a UNIX/LINUX based
system. Characters sent from the PC are not echoed by the device and a <CR><LF> is sent after
the cursor to force a flush of the USART buffer.
Revision 1.0
Torridon HS Lite Drive Control Module - Technical Manual
©Quarch Technology
[The parent family of the device]
[The name of the device]
[The part number of the hardware]
[Part# and version of firmware]
[Part# and version of bootloader]
[Version of FPGA core]
Page 19 of 28