Control Register Map - Quarch Technology Torridon HS Technical Manual

Control Register Map

This map is provided for backwards compatibility with old modules only. While you can use the
'Read' and 'Write' commands, we STRONGLY recommend you use the SCPI based 'Signal' and
'Source' commands instead of writing to the registers.
Address
0x00
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x18
0x29
0x3A
0x4B
0x5C
0x6D
0x6E
0x6F
0x70
0x71
0x72
0x73
0x74
Revision 1.0
Torridon HS Lite Drive Control Module - Technical Manual
Name
Global Control
Reserved
Reserved
Reserved
S1 & S2 Control
S3 & S4 Control
S5 & S6 Control
S1 Initial Delay
S2 Initial Delay
S3 Initial Delay
S4 Initial Delay
S5 Initial Delay
S6 Initial Delay
3V3_CHARGE,3V3_POWER
5V_CHARGE,5V_POWER
12V_CHARGE, 12V_POWER
SPECIAL1 (Mated),PRI_OUT_PL
PRI_OUT_MN, PRI_IN_PL
PRI_IN_MN, SEC_OUT_PL
SEC_OUT_MN, SEC_IN_PL
SEC_IN_MN
©Quarch Technology
Description
Initiate a hot swap event
Reserved
Reserved
Reserved
Enable Sources 1 and 2
Enable Sources 3 and 4
Enable Sources 5 and 6
Set the source 1 delay
Set the source 2 delay
Set the source 3 delay
Set the source 4 delay
Set the source 5 delay
Set the source 6 delay
Signal control register
Signal control register
Signal control register
Signal control register
Signal control register
Signal control register
Signal control register
Signal control register
Page 23 of 28