Inter-m RMX-1426 Operating Manual page 7

6 6
9. ON SWITCH
This switch turn the PGM 1~4, ST on/off.
The output signal is on when the switch is pressed in. When off, the output signal will be muted.
10. MASTER FADER CONTROL
This fader adjusts the signal level to the PGM 1~4, ST.
11. METER SELECT SWITCH
The meters are dual function LED meter that indicate signal levels as selected by the meter select switch.
When meter select switch is off : display of the STEREO L/R output
When meter select switch is on : display of the headphone or monitor output
12. METER DISPLAY SECTION
These meters indicate the output level to the PGM 1~4, and ST or monitor.
13. PFL INDICATOR
This indicator will light when a PFL switch is turned on.
14. PHANTOM POWER
This switch turns on/off the phantom power supply for all input channels.
Use this switch when you are using condenser microphones.
When this switch is turned on, DC +48V will be supplied to pin 2 and 3 of each input XLR connector. If you
do not need phantom power, be sure to leave this turned off.
It is safe to connect balanced dynamic microphones or line level devices even if this switch
is on, but connecting unbalanced devices or device whose transformers are center-grounded will cause
hum or malfunctions.
Indicator will be light when PHANTOM switch is on.
15. POWER SWITCH
The power switch is used to turn on and off the AC main power.
The indicator will light when POWER switch is ON.