JB Systems CLUB7USB Operation Manual page 7

ENGLISH
15. Play sequence selector: two play sequences are available:
 STRAIGHT play sequence: The next song is determined by alphanumerical sorting.
 RANDOM play sequence: The next song is determined by random choice.
16. Media PLAY/PAUSE/STOP button: Press briefly to toggle between PLAY (backlight lit) and PAUSE
(backlight flashing) mode. Press for longer than 2 seconds to change into STOP status (backlight off).
17. Folder level button: Press the button to go to folder level and use Rotary dial (19) to select the desired
folder.
18. Time Display selector: Selects between elapsed/remaining time display. The display shows [E] for
Elapsed time or [R] for Remaining time (see display "B" and "C") and is always related to track currently
playing.
19. Rotary dial: Turn the dial knob to choose a song or a folder. Press the the dial knob to confirm your
choice. Your choice is immediately active.
20. HEADPHONE JACK: You can monitor all inputs/outputs when you connect any modern stereo
headphone to this 6.3mm jack.
21. [CUE VOLUME]: Used to control the output level of the headphone output.
22. [CUE MIX]: With this knob you can mix the master output and any of the input channels through the
headphone output (20):
 Put the knob in the extreme left position to monitor a selected PFL signal (26).
 Put the knob in the extreme right position to hear the master output.
 Put the knob in any other position to hear a mix of the two signals.
This option makes it possible to check your mix before you put it on the master output.
23. [CROSSFADER] ASSIGN: Selects the input channels to be used with the crossfader (24).
24. [CROSSFADER]: With this VCA fader you can mix over between the channels you selected with the
crossfader assign selectors (23). The crossfader only works when you move the selected channel faders
(27) to the desired level!
25. [CROSSFADER] ON/OFF: Switches on and off the crossfader (24).
26. [PFL SELECTOR]: Used to select the source (CH-1 to CH-4) to be monitored via the headphones
output.
27. CHANNEL FADER: Used to set the level of each channel separately.
28. 3-BAND TONE CONTROLS: The frequency [(HIGH-MID-LOW)] of each channel can be controlled
separately over a range from -26dB to +12dB. In the center position the tone control is flat.
29. ON/OFF SWITCH MIC 1-2-3: Switches on and off the microphones (MIC 1 – MIC 2 – MIC 3)
30. LEVEL MIC 1-2-3: Adjusts the input level on the microphone channels (MIC 1 – MIC 2 – MIC 3). Use
this control to adjust the level on the VU-meter at about 0dB.
31. MIC INPUT JACK: Combo jack. Accepts either a balanced microphone with an XLR connector or an
unbalanced microphone with 1/4" mono jack.
JB SYSTEMS 5/7
USER MANUAL
Club7usb