Inside The Front Cover - Panasonic WJ-HDE400 Installation Manual

Inside the Front Cover

(1) HDD unit
HDD in special canister
The HDDs can be added and replaced by using the front
panel of the network disk recorder. Refer to page 22 for
details. Contact your dealer for information on purchasing
and replacing HDDs.
(2) HDD status indicator [STS]
Shows the operating status of the HDDs.
Lights green : HDD power [On]
(Formatted)
Blinks green : HDD for playback only
(only for playback, recording not
possible)
Blinks orange : Formatting HDD
Lights red : HDD format failed
Off : HDD power [Off]
HDD
recognized.
(3) HDD access indicator [A/F]
Indicates the access status and problems with the HDD.
When errors occur on an HDD in RAID5/RAID6 mode, the
indicator lights or blinks red.
Blinks green : Accessing HDD
Off : Not accessing HDD
Lights red : Errors have occurred on HDD
(Data can be recovered by replacing
HDD)
• When in RAID5 mode, the first HDD
has errors
• When using RAID6, the first two
HDDs have errors
Major Operating Controls and Their Functions
(1) (2) (3)
(5)
is not connected or not
(4)
Blinks red : Errors have occurred on HDD
(Data cannot be recovered even if
HDD is replaced)
• When in RAID5 mode, the second
HDD has errors
• When in RAID6 mode, the third HDD
has errors
Lights orange and : Recovering data from drive in RAID5/
red RAID6 mode.
(This indicator looks orange during
(Alternately)
high-speed processing.)
(4) HDD bay slots
Up to 9 HDD units can be installed.
Note:
• Limiting factors for the RAID5/RAID6 mode
RAID5 mode : The RAID5 mode can be used when
more than three HDDs are installed.
RAID6 mode : The RAID6 mode can be used when
more than four HDDs are installed.
(5) Removal knob
Used when replacing the HDD units.
11