Table of Contents
Advertisement
Installing HDDs
You can install (link) HDDs from the recorder while it is in operation.
Also, refer to the network disk recorder's Installation Guide.
1
Insert the key (included) into the key hole and turn it to
the right while pressing gently to open the front cover.
(2)
2
Insert the HDD units into the HDD bay slots while
checking each HDD number marked on the HDD bay
slots.
Press the HDD unit's removal knob down and lift the lever,
and then insert it all the way into the disk slot.
(1)
Hook the HDD unit's tab securely on the
HDD bay slot.
(2)
Press the lever down and push the HDD
unit until the removal knob clicks.
(1)
(2)
3
The HDD will be automatically recognized.
•
While the HDD is being recognized, the HDD status
indicator blinks orange.
Once the HDD is recognized, the HDD status indicator
lights green or blinks.
•
The HDD is automatically formatted if it is not
preformatted.
The HDD status indicator lights green after formatting is
complete.
•
Preformatted HDDs are recognized for playback only. In
this case, the HDD status indicator blinks green. Follow
the instructions from step 4 to use the HDD for recording.
(1)
(1)
Using the Front Panel for Operations
Note:
•
The HDD status indicator may light green before blinking
orange when an HDD is inserted.
The following operation is done on the network
disk recorder
4
Press the [USE] button for over 2 seconds.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
5
Press the arrow buttons (up or down) on the front panel
until [HDD Operation] appears on the screen.
6
Press the [SET] button.
7
Press the arrow buttons (up or down) on the front panel
until [Link HDD] appears on the screen.
8
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
9
Select the device where you installed the HDD (Network
Disk Recorder: MAIN, Extension Unit (x): EXTx) with the
arrow buttons (up or down) and press the [SET] button.
10
Select the device where you installed the HDD with the
arrow buttons (up or down) and press the [SET] button.
11
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
The HDD is recognized for recording.
Press the [SET] button to return to the time display format
screen.
23
Advertisement
Table of Contents
