| eK43 S | en Scope of delivery Name Bean container with lid Bean container feeder on switch i Off switch 0 Lever for bag clamp / knocker Spill tray outlet Bag clamp / knocker Hand wheel (grind adjustment)
CommerCial Coffee grinder General information Read operating instructions and keep safe Before you start using the EK43 (S) commercial coffee grinder, carefully read through this original instruction manual and the safety information. Only then will you be able to use the com- mercial coffee grinder safely and without danger.
Page 11
| eK43 S | en This symbol provides you with important information concerning operation or handling. Conformity declaration (see chapter “Conformity declaration”): Products marked with this symbol fulfil all applicable community provisions of the European Economic Area. ETL Listed seal of approval: Products marked with this symbol meet the requirements for electrical product safety of the United States of America.
CommerCial Coffee grinder Safety Intended use The grinder is designed to grind whole roast coffee beans. If necessary, you can convert the grinder so that it can be used to grind other foods such as certain types of grain. Contact your dealer for information on this. The grind- er may only be used to grind the materials for which it has been designed.
Page 13
| eK43 S | en In the event that the power connection at the site of installation of the grinder is not secured in this way, have a 16 A-slow back-up fuse fitted by a qualified electrician. – Install the grinder only in places where the handling of the grinder can be supervised by trained personnel.
Page 14
CommerCial Coffee grinder WARNING! Danger for children and persons with reduced physical, sensory and mental abilities (e.g. partially disabled persons, older persons with limited physical and mental abilities) or a lack of experience and knowledge (e.g. older children). – This grinder may be used by children older than eight years and by persons with reduced physical, sensory or mental disabilities or a lack of experience and knowledge if they are supervised or instructed on the safe use of the grinder and have understood...
| eK43 S | en Before using Checking grinder and scope of delivery INFORMATION! Risk of damage! The grinder can become damaged if the packaging is opened careless- ly with a sharp knife or other pointed object. – Be very careful when opening.
CommerCial Coffee grinder Connecting the potential equalizer The connection for potential equalization (12) is located on the back of the grinder (see Fig. B). The electrical connection and testing of electronic func- tionality must be carried out by an electrician. 1.
5. Put a coffee bag over the outlet or position a suitable grounds container underneath it. • Due to its height, the EK43 S model is not designed for bag grinding. Use a suitable grounds container instead (not included with delivery).
CommerCial Coffee grinder Starting grinding 1. Start grinding by pulling out the sliding valve (11) and thus opening the bean container in the direction of the burr assembly (see Fig. C or D). The grinder will grind the filled volume of coffee beans. 2.
| eK43 S | en INFORMATION! Risk of short-circuit! Water penetrating the grinder can cause a short-circuit. – Never immerse the grinder in water or any other liquids. – Never clean the grinder with a water jet. – Also ensure that no water or other liquids make their way into the casing.
CommerCial Coffee grinder Cleaning the casing 1. Switch off the grinder and remove the power plug (14) from the socket. 2. Let the knocker (8) tap against the outlet (7) a few times using the lever (5) to shake out any remaining grind residue from the outlet (see Fig.
| eK43 S | en Cleaning the burr assembly • The manufacturer recommends using the grinder cleaner grindZ . For more information about GRINDZ visit www.mahlkoenig.de. • The burr assembly should be cleaned every 2–5 days. 1. Make sure that the sliding valve (11) encloses the bean container (1) in the direction of the burr assembly.
CommerCial Coffee grinder Troubleshooting Error Cause Remedy The grinder is • The outlet is t Using the hand wheel, set the humming but clogged. grinding degree setting to the not grinding. coarsest grind and trigger the grinding process. The grinder will grind itself clear.
Page 23
| eK43 S | en Error Cause Remedy The grinder is • The power plug t Insert the mains plug into a prop- not grinding or is not plugged erly installed wall socket. buzzing. into a socket. • The thermal...
| eK43 S | en Disposal Disposing of the packaging Dispose of the packaging by correctly sorting the recyclable materials. Dispose of card and cardboard as waste paper, and film as recyclable materials. Disposing of the grinder Old appliances may not be thrown into commercial/domestic waste!
Need help?
Do you have a question about the EK43 S and is the answer not in the manual?
Questions and answers