Mitsubishi Electric MELSEC FX2N-32DP-IF Hardware Manual page 13

FX2N-32DP-IF Profibus-DP Interface Unit
a) Profibus-DP communication port (D-SUB 9 pin)
b) Power supply terminals (screw terminal: M3.5 (0.14"))
FX -32DP-IF (AC power supply type): L, N and grounding terminal
2N
FX -32DP-IF-D (DC power supply type): 24+, 24- and grounding terminal
2N
c) Direct mounting hole (2-φ4.5 (0.18"))
d) 24 V DC power terminal (screw terminal: M3.5 (0.14"))
FX -32DP-IF-D does not have this terminal.
2N
e) RUN/STOP switch: When this switch is in the RUN position, the 32DP-IF will exchange
f) Communication port for FX-20P-E or personal computer
g) POWER LED:
h) RUN LED:
i) BF LED:
j) DIA LED:
k) Hook for DIN rail mounting
l) DIP switches for slave address of this unit
m) Extension port
n) Groove for DIN rail mounting (DIN rail width: 35 mm (1.38"))
data with extension units/blocks and special function blocks. If this
switch is in the STOP position, the 32DP-IF will exchange only input
data with extension units/blocks.
ON when power is supplied.
ON when 32DP-IF is exchanging data with extension units/blocks
and special function blocks.
ON when a communication error is detected (No data exchange).
ON when diagnostic data is detected.
Introduction 1
1-3