Configuration (Standalone); Static Color Mode; Auto Program Mode; Custom Static Color Mode - Chauvet DJ COLORband HEX 9 IRC User Manual

Configuration
(Standalone)

Static Color Mode

Auto Program
Mode
Custom Static
Color Mode
COLORband™ Hex 9 IRC User Manual (Rev. 1)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To enable the Static Color Mode, do the following:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose a color (C1-C63).
4. Press <ENTER>.
To enable the Auto Program Mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose your auto program (P1-P14).
4. Press <ENTER>.
You can adjust the speed of the automatic program as well.
1. Press <MENU> repeatedly until S-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to adjust the duration of each step of the automatic program
from S001 (slow) to S100 (fast).
4. Press <ENTER>.
To enable the Custom Static Color Mode, follow the instructions below:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> to choose between colors (r--, g--, b--).
3. Press <UP> or <DOWN> to choose the intensity of the color (r000-100).
4. Repeat the steps to mix additional colors to create the color you need.
5. Press <ENTER>.
Page 15 of 20