Master/Slave Mode - Chauvet DJ COLORband HEX 9 IRC User Manual

IRC-6
(Infrared Remote
Control)
IRC-6 Operation Make sure to point the IRC-6 directly at the receiver on the product
Master/Slave
Mode
Page 16 of 20
The
COLORband™ Hex 9 IRC
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to switch between preprogrammed auto programs.
To adjust the speed of the automatic program:
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to either increase or decrease the speed of the program.
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
·
Press <SOUND> on the IRC-6.
To adjust sound sensitivity in Sound-Active mode:
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to either increase or decrease sound sensitivity.
Preprogrammed Colors
To choose a specific color with the IRC-6:
·
Press any number between <0> and <9> to choose your color.
The Master/Slave mode allows a single COLORband™ Hex 9 IRC unit (the "master") to
control the actions of one or more COLORband™ Hex 9 IRC units (the "slaves") without
the need of a DMX controller. The master unit will be set to operate in a standalone
mode while the slave units will be set to operate in Slave Mode. Once set and
connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1. Set the DMX address to 001.
2. Connect the DMX input of the first slave unit to the DMX output of the master unit.
3. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
4. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in a standalone mode.
2. Make the master unit the first unit in the daisy chain.
·
Configure all the slave units before connecting the master unit to the daisy
chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
is compatible with the IRC-6 from Chauvet.
COLORband™ Hex 9 IRC User Manual (Rev. 1)