Using Light/Loc - Uniden WHAMx4 Owner's Manual

WHAMx4 Paper OMNEW.fm Page 19 Thursday, January 27, 2005 2:34 PM
the units that they want to talk to: base radio 1, base
radio 2, WHAM 2, WHAM 3, WHAM 4, All, Group 1,
or Group 2. For which WHAM's will be on the list will
depend on which WHAM number the user is using (
for the above example, the user is using WHAM 1).
There are 2 user programmable Groups for the
intercom. The following shows the Intercom select
screen.
Pressing the Select key or the PTT key will choose
the Intercom mode.
NOTE: The user has to set-up the Group 1 and
Group 2 in the Setup menu.
NOTE: Base Radio 2 will only be active in the menu
after the WHAMx4 is registered to recognize this
radio for Intercom purposes only.
NOTE: To use the PA feature, the user would just
install a non-listen-back type of speaker horn.

Using LIGHT/LOC

Press this key briefly to activate the Low backlight
setting. Press this key for a second time to select
the Medium backlight setting. Press this key a third
time to select the High backlight setting. Press this
key a fourth time to select the backlight Off setting.
Press and hold this key for ~2 seconds to activate
the Keylock feature. The only active key while in the
keylock mode is the PTT key. Either by pressing the
Light/Lock key for ~2 seconds, while in the Keylock
mode, or by turning off then on the WHAMx4 will
disable the Keylock feature.
Operation 19