Table of Contents
Advertisement
6. Basic Planning and Layout Considerations
• Where will the speakers be located ?
• How will the wiring be routed to each
location ?
• Where will the keypads be located ?
• Where is the equipment located ?
• Where is the CA4.4pi controller going
to be located ?
7. Back Panel Connections
7.1 Source Input Connections
• Your source inputs are located at the top left corner of the back panel. Connect each source output, left and
right, using quality signal cables / patch cables. Label each cable the name of your source and the input num-
ber of the CA4.4pi you have selected. Repeat until all sources are connected. List them down below.
figure 1: Input 1 ______________ Input 2 ______________ Input 3 ______________ Input 4 ______________
7.2 Speaker Connections
• Keeping in mind the location of the corresponding keypad, connect your speakers by first removing the con-
nector. Using wire strippers, strip back 1/8" of the end of the wire. Insert the proper polarity, left + to left +, left-
to left- etc., until all wires are connected in each zone output. Label each wire with the room name and zone
number. Write down the room name to the zone number below. Note: We recommend 8 Ohm minimum
speakers for each zone. However, as low 4 Ohm speakers can be safely used in up to two zones if necessary.
figure 2:
(Color) Left + _______________ Left - _______________ Right + _______________ Right - _______________
Zone 1 ________________________________________ Zone 2 ________________________________________
Zone 3 ________________________________________ Zone 4 ________________________________________
T
UNER
R
L
12V
IR
T
L
RIG
INK
12V
IR
Trigger
Link
4
Connection Tips
• Disconnect all power cords before connecting to the CA4.4pi.
• Verify that all connections and polarity are correct.
• Keep all power cords away from all signal cables to prevent
• Choose reliable signal cables / patch cords.
• Label all wires with room location at both ends of the wire.
• Take your time!!! Don't panic about the number of wires;
Source Inputs
CA4.4pi
NEWMARKET, NH U.S.A.
CD
T
A
APE
UX
IR R
O
EMOTE
UTPUT
4
3
2
1
USE #1 FIRST
Emitter Outputs
noise or humming.
simply connect one at a time.
4
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
4
TUNER
S
CD
O
U
R
Keypad Zone
TAPE
C
E
AUX
Connectors
• ON / OFF
• VOLUME
• SOURCE
SOURCE
REMOTE SENSOR
I
F
K
NPUT
ROM
EYPADS
3
2
1 2 3 4 5 6 7 8
O
T
8 S
UTPUT
O
PEAKERS
3
2
Speaker Output
Connectors
1
1 2 3 4 5 6
1
Advertisement
Table of Contents
