Table of Contents
Advertisement
Quick Links
p/n 31114
Kit #12111
Skill Level 4
V-2 Conversion Kit
Converts the Spacemonkey Models
V-2/A4 Plastic Model Kit into a Flying
Model Rocket
Parts List
P/N
Item Name
10091
AT-24/3.75"
10128
AT-33/17.75 (LC)
12358
CBD-33mm ⅛" Plywood (single)
13016
Coupler AC-33 (single)
13031
CR-18/24 (single)
13301
CR-24/33 ⅛" Plywood (single)
13279
CR-33 V-2 (LC)
13056
¼" Launch Lug
24043
Crimped Engine Hook
29520
300# Kevlar X 8 ft
29602
Clay Nose Wt (⅓ stick) {30 grams}
29624
Wood Screw Eyebolt Size 9
29116
24" Plastic chute
31114
Instruction Sheet A
31115
V-2 Launching Instructions
47124
Clear Plastic Bag 6X24X2mil
Supplies Needed
Spacemonkey Models V-2/A4 Plastic Model Kit
Pencil
Hobby Knife
Razor Saw
Wood Dowel or Stick (to spread glue inside tube)
Ruler
Sand Paper (220 and 400 Grit)
Wood Glue
Super Glue (Thick Viscosity)
Rocket engine to push in the engine block
The V-2 Conversion kit is another fine product from:
Colorado Springs, Colorado USA
web site: www.ApogeeRockets.com
Made in USA
Qty
1
1
1
1
1
2
1
1
1
1
1
1
1
1
1
1
Page 1
Advertisement
Table of Contents
Related Manuals for Apogee V-2 Conversion Kit
Summary of Contents for Apogee V-2 Conversion Kit
-
Page 1: Parts List
Sand Paper (220 and 400 Grit) Wood Glue Super Glue (Thick Viscosity) Rocket engine to push in the engine block The V-2 Conversion kit is another fine product from: Colorado Springs, Colorado USA web site: www.ApogeeRockets.com Page 1 p/n 31114... - Page 2 This conversion kit should be assembled prior to the assembly of the plastic model rocket. That way when you’re ready to add the fins and the other delicate details, there will be less of a chance to damage the plastic parts. V-2 Conversion Kit Assembly 2-1/4” (57mm) Step 1 - Mark the short white body tube 2-¼...
- Page 3 insert the motor mount tube into the aft end of the body tube SO THE BACK RING IS RECESSED AT LEAST ¼ INCH (6.5mm) INSIDE THE END OF THE TUBE. Also, the engine hook should NOT be in line with the line on the tube.
- Page 4 Step 12 - Screw and then glue the screw-eye into the wooden bulkhead disk using wood glue. Glue the assembly into one end of the red tube coupler. The disk should be just inside the end so that you can put glue fillets on both sides of the disk.
- Page 5 V-2 Launching Instructions Launch Supplies Needed To launch your rocket you will need the following supplies: • A model rocket launching system • Flame resistant recovery wadding • Recommended Rocket Engines: C11-3, D12-5 Rocket Preflight A. Crumple and insert 5 sheets of recovery wadding into the body tube. B.
Need help?
Do you have a question about the V-2 Conversion Kit and is the answer not in the manual?
Questions and answers