Make sure Wood glue the wider end sticks up from the side of the goes here sled that shows the Apogee logo imprint. Once securely in place, dab a small amount of wood Side View Step 7 glue on the joining pieces along the non- Apogee side and let dry.
Page 4
Sled Assembly Continued... 9. Place the smaller of the disks, “B1” on the “E2” end of the sled and slide it up until it stops. Now apply a small amount of wood glue to the outside surface of the “B1” disk. Then Apply the wood glue here before take your larger disk “B2”...
Page 5
Sled Assembly Continued... 14. Once your corresponding holes are determined, carefully remove the laser cut holes on the sled with a small screwdriver or pencil. Feel free to rub a small amount of wood glue into the remaining holes that won’t be used to seal them.
Igniter Assembly Drogue/Apogee Igniter goes around the “C” shape towards “E1” Side 22. Trim the exposed wires on the igniters to (bottom of the rocket) 1/8th inch. This will prevent any shorts from the exposed wires touching each other. Then attach...
Page 7
32. For the Main igniter setup, repeat steps 30 & 31 above. 33. Tie the shock cord from the main body tube of the rocket to the “E1/Apogee” side of the sled. Use a knot that you can untie easily after launch.
Page 8
www.ApogeeRockets.com Go online and order at the website above or call us and order at 719-535-9335. We’re available M-F: 9:00am-5:00pm MST. ✓ Recommended items: Product Number 4-40 Tap and Drill Set 02090 Altimeter Options: Easy Mini 09201 PerfectFlite StratoLogger CF 09104 2 Quest Q2G2 Long Motor Starters 03079...
Need help?
Do you have a question about the 10545 and is the answer not in the manual?
Questions and answers