NEC NVM-2000 Installation Manual page 7

Issue 1-0
10. Remove all jumpers from the expansion (slave) hard drive. However, do not change any
jumpers on the hard drive (master) that is installed in your cabinet.
11. Secure the two U brackets (labeled as A and B on Figure 4) on the expansion hard drive as
shown in Figure 4.
A
12. If your cabinet has a front panel that is secured with spring clips (as shown in Figure 3), then
go to step 12. If your cabinet has a front panel like Figure 5, then perform the following steps:
Remove and retain the screws securing the hard drive/floppy drive bucket assembly to the
side of the expansion hard drive cage (see parts A and B, respectively, on Figure 6).
Installing an Expansion Drive
B
QUANTUM drive
Figure 4
Figure 5
Install the Drive
DT-expHD-6
DT-expHD-7
3