NEC NVM-2000 Installation Manual page 15

Write the Hardware Settings for the New Drive to CMOS
Issue 1-0
Procedure B: Write Expansion Drive Settings to CMOS
Note: You should have completed the two steps in Determine the Proper Procedure for
Writing to CMOS (on page 10) before you continue with this procedure.
To write the hardware settings for the Expansion Drive to CMOS:
Wait for the CMOS SETUP UTILITY menu to appear.
1.
From the CMOS SETUP UTILITY menu, use the Arrow key to move to the option IDE
2.
HDD AUTO. You will see Auto Configure HDD: Sector, Cylinder, Head at the bottom of the
screen.
3. Press <Enter>. You will see:
Select Primary Master Option (N=Skip) : N
At the flashing N, press Enter. You will see:
4.
Select Primary Slave Option (N=Skip) : N
At the flashing N, enter Y and press Enter. You will see:
5.
Select Secondary Master Option (N=Skip) : N
At the flashing N, press Enter. You will see:
6.
Select Secondary Slave Option (N=Skip) : N
Press Enter. You will return to the CMOS SETUP UTILITY menu.
7.
Press F10 to Save and Exit from the CMOS SETUP UTILITY
8.
9. At the prompt, SAVE to CMOS and EXIT (Y/N), enter Y and press Enter.
NVM will boot up.
Installing an Expansion Drive
11