NEC NVM-2000 Installation Manual page 6

Installing an Expansion Drive
Install the Drive
2
8. Remove the cabinet cover as follows:
If the power switch on your cabinet is mounted on the rear of the cabinet (above the power
supply vent fan), slide the cover/front panel assembly 1 3/4 inches towards the front of the
cabinet, and lift up. See Figure 2.
If the power switch on your cabinet is mounted on the front panel, slide the cover 1/2 inch
towards the rear of the cabinet and lift up. See Figure 2.
Slide 1/2“, then lift.
Power Switch
mounted at
rear of cabinet.
DT-expHD-2
9. On many styles of desktop cabinets, the front panel would have been removed when you lifted
off the cabinet cover. If your front panel is removed, go to step 9. If it is still attached:
Do not remove the front panel if it is secured to the cabinet with screws. Go to step 9.
If your front panel is secured to the cabinet with 5 metal spring clips:
Grab the notch located beneath the front panel (on the end where the logo is located)
and firmly pull the front panel away from the chassis. See Figure 3.
1/2“
1 - 3/4“
Figure 2
Grab at notched
area and pull.
Figure 3
Power Switch
mounted on
front panel.
Slide 1-3/4“, then lift.
DT-expHD-3
Issue 1-0