NEC NVM-2000 Installation Manual page 11

Issue 1-0
Use Figure 3 as a reference for panel location. To re-attach the front panel to the cabinet,
simply push the spring clips into the holes of the cabinet until the clips snap and lock the
front panel in place.
Go to step 13.
14. Disconnect the ribbon cable from the master hard drive.
15. Plug the end connector of the ribbon cable into the expansion hard drive. See Figure 12.
Insert the connector on the ribbon cable so that the red stripe on the rib-
bon cable is closest to the power connector on the hard drive.
red stripe
Note: For clarity, floppy ribbon cable and
all power wires are not shown.
Installing an Expansion Drive
IMPORTANT
Figure 12
Install the Drive
DT-expHD-13
red stripe
7