Main Menu; Input Source; Aspect Ratio - Runco Video Xtreme VX-40d Owner's Operating Manual

The Main Menu is the starting point for accessing all projector functions.
(The Calibration and Service menus are hidden and not accessible until you enter a
passcode.)
From the Main Menu, select Input Source to choose a video signal source.
The active source is indicated by an arrow (>) to its left; in the example at left, Composite
is the active source.
1. HD Pass Thru 1 and HD Pass Thru 2 are available only when the
Note
2. Selecting HD Pass Thru 1 or HD Pass Thru 2 loops the
3. If the DVI 1 or DVI 2 input is active and the input signal is
To change the aspect ratio (size and shape) of the projected image, select Aspect Ratio
from the Main Menu and press ENTER. Select the appropriate aspect ratio for your
screen size and the type of program material being viewed; refer to Table 4-1.
The currently-selected aspect ratio is indicated by a "
Anamorphic is selected.
The aspect ratio selection is automatically saved for each input and
Note
resolution.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
Display Device Input Source is set to RGB; refer to Display
Device on page 70.
HD/RGB 1 or HD/RGB 2 input signal respectively to the RGB
output. This prevents display of the on-screen menus. To switch
from HD Pass Thru 1 or 2 to another source, use the direct
access buttons on the remote control, or the left- or right-arrow
buttons on the DHD Controller.
HDCP-encrypted, the RGBHV output of the DHD Controller is
disabled.
" to its left; in the example at right,
59
Operation

Main Menu

Runco Video

Input Source

Aspect Ratio

Picture
Input Position
ISF Presets
Information
Calibration
Service
Input Source
Input Source
> Composite
S-Video 1
S-Video 2
Component SD
HD/RGB 1
HD/RGB 2
DVI 1
DVI 2
HD Pass Thru 1
HD Pass Thru 2
Aspect Ratio
Aspect Ratio
Anamorphic
Standard 4:3
Letterbox
VirtualWide
Cinema
Virtualwide 2.35