Setting Up The Monitor; Installing The Monitor Stand; Connecting The Cables - HP 54.61 cm/21.5-inch User Manual

Setting up the monitor

Installing the monitor stand

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity
of color or disorientation of the liquid crystals. If this occurs, the screen will not recover to its normal
condition.
1. Place the monitor face down on a flat and clean surface.
2. Insert stand riser and base into the monitor as shown above.

Connecting the cables

NOTE: The monitor ships with select cables. Not all cables shown in this section are included with the
monitor.
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Connect a video cable.
NOTE: The monitor will automatically determine which inputs have valid video signals. The inputs can
be selected by pressing the Menu button to access the On-Screen Display (OSD) menu and selecting
Input Control.
• Connect one end of a VGA cable to the VGA connector on the rear of the monitor and the other end
to the VGA connector on the source device.
NOTE: Connector locations may vary.
1
2
or
1 Getting Started 5