Charging Bay - Pm-X00-731; Installation And Removal - BRASSELER USA BSP MAX II Instructions For Use Manual

Charging Bay – PM-X00-731
The 4-Bay Power Unit can be configured with a combination of Charging Bay(s) and Bay Cover(s). The 4-Bay
Power Units (PM-X00-520 and PM-X00-522), Standard Battery Pack Charging Bay (PM-X00-731) and Charging
Bay Cover (PM-X00-521) are sold separately. The power unit charges up to four battery packs simultaneously.
Cautions:
• DO NOT over tighten screws.
• DO NOT connect power cord to the electrical connector inside the charging bay.
Tool Required:
• Standard Phillips #2 (medium size) Screwdriver.
Installation & Removal
Charging Bay Installation:
• Loosen screws and remove Charging Bay Cover.
• Align front Charging Bay tab with Power Unit slot.
• Lower the Charging Bay into the corresponding side
slots and power input connection. Ensure Charging Bay
tabs are aligned with Power Unit slots.
• Apply light force to seat fully.
• Tighten screws with screwdriver.
• Verify that the Charging Bay is flush with the top
surface of the 4-Bay Power Unit and that the front
tab is engaged into power slot.
Charging Bay Removal:
• Loosen Screws.
• Remove Charging Bay.
• Install Charging Bay Cover (PM-X00-521).
8
Charging Bay Cover
Charging
Bay Tab
Power Input
Connection
Charging
Bay Tab