Maintenance - Aeros COMBAT 12T Owner's Service Manual

METHOD OF SPROG ADJUSTMENT
To adjust the outboard sprog angle:
1. Fully unzip the access zipper to gain access to the sprog-LE tube connection.
2. Remove the pin from the sprog threaded adjuster at the front of the sprog. To raise the sprog angle
turn the end of the sprog threaded adjuster counter clockwise. To lower the sprog angle turn it clockwise.
3. Re-install the pin to the sprog threaded adjuster, zip the access zipper up and press down firmly on the
rear end of the sprog to seat the cable before checking the measurement again.
To adjust the main sprog angle:
1. Fully unzip the access zipper to gain access to the crossbar-LE junction.
2. Remove the pin from the sprog threaded adjuster at the front of the sprog. To raise the sprog angle
turn the end of the sprog threaded adjuster counter clockwise. To lower the sprog angle turn it clockwise.
3. Re-install the pin to the sprog threaded adjuster, zip up the access zipper and press down firmly on the
rear end of the sprog to seat the cable before checking the measurement again.

MAINTENANCE

This section contains a recommended schedule of periodic maintenance. None of the items in this section
are a substitute for the continual and consistent practice of proper pre-flight inspections and immediate
maintenance of any items on the wing, which require it. Safety requires that your wing be fully airworthy
for every flight. Nuts and bolts must always be secure, safety rings must always be in place, and damage
to any part, which could compromise the airworthiness of the wing, cannot be tolerated. If you have a
question about the need to repair or replace some part of your wing, feel free to contact your dealer or
Aeros directly. It is not always obvious which items require attention and which may not. Minor dents or
dings in a non-critical location on an airframe tube may not require any repair or maintenance. On the
other hand, a wire that has been kinked one time can fail very quickly after that, and should be replaced
immediately.
We recommend that you have all maintenance work done by your Aeros dealer.
EVERY SIX MONTHS
1. Measure the sprog angle as described in the last section.
17