Picture Quality Adjustments - Runco DTV-947 Owner's Operating Manual

MENU DESCRIPTION AND NAVIGATION
Aspect Ratio allows selection of one of the three aspect ratios provided by the
controller. You have two options for selecting an aspect ratio: First, highlight
ASPECT RATIO on the main menu, then press ENTER. Then select the desired
aspect ratio, and again press ENTER. The second option is to simply press the UP
or DOWN arrows on the remote or front panel. Doing this will toggle you through
the three choices- Anamorphic (16:9), Letterbox and Standard (4:3). For more infor-
mation on aspect ratios, please refer to Page 11-18.
Pass Through Setup: The settings for this will tell the projector which source (RGB
or Component) and aspect ratio to 'look at' when using the pass-through connectiion
on the Controller. For example, if using a computer via the Pass-Through port on the
Controller, this setting should be 'Computer'. However, if a DTV decoder with a com-
ponent output is used, the setting should be on 'YUV HDTV'.

Picture Quality Adjustments

MAIN MENU
> COMPOSITE
S-VIDEO
COMPONENT
PASS THROUGH
ASPECT RATIO
DISPLAY CONTROL
Picture quality adjustments are those that change the various parameters of the
image, such as COLOR (saturation level) and BRIGHTNESS (black level), among
others. Typically, these adjustments should be made only once (during initial calibra-
tion) and then left alone. However, if it is necessary to make any adjustments, per-
form the following procedure:
In the example above, note that COMPOSITE is the active source. This is indicated
by an arrow to the left of the word 'COMPOSITE'. To make adjustments, highlight
the active source (composite in this case) and press ENTER.
Note:
Pressing ENTER after highlighting a different source will switch you to that
source instead of making picture quality adjustments.
ADJUST
TINT
COLOR
BRIGHTNESS
CONTRAST
SHARPNESS
LUMA ENHANCE
CHROMA ENHANCE
VCR MODE
11-15