Remote Control Description - Runco DTV-947 Owner's Operating Manual

Remote Control Description

A. LED
Lights when a button is pressed indicating IR output.
B. POWER BUTTON
Turns the unit on. The MAIN POWER switch on the rear of the unit must
be on first for this button to be active.
C. UP BUTTON
When no menu is present on-screen, this button will toggle you through
the different aspect ratios.
When the menu is on-screen, the up button will move the cursor up within
a menu.
D. LEFT BUTTON
When no menu is present on-screen, this button will toggle you through the
four different sources, in the order of:
COMPOSITE
When an adjustment function has been selected (i.e. Brightness), the
LEFT button will decrease the value of that function.
E. DOWN BUTTON
When no menu is present on-screen, this button will toggle you through
the different aspect ratios.
When the menu is on-screen, the down button will move the cursor down
within a menu.
F. RIGHT BUTTON
When no menu is present on-screen, this button will toggle you through
the four different sources, in the order of:
PASS THROUGH
When an adjustment function has been selected (i.e. Brightness), the
RIGHT button will increase the value of that function.
G. MENU BUTTON
The MENU button brings up the main adjustment menu. After making
adjustments, the MENU button will bring you back to the sub-menu, then
the main menu. The Menu will then either time-out after approximately 10
seconds, or pressing the MENU button will remove the menu immediately.
H. ENTER BUTTON
When an item is highlighted on the On-Screen Display, the ENTER button
will select the item.
I. PROGRAM BUTTON
Reprogramming of the remote control with lost memory.
J. DIRECT ACCESS BUTTONS
These buttons are a shortcut that allow you to go directly to a particular
source of Aspect Ratio, as well as provide discreet ON/OFF commands.
These buttons are:
S-VIDEO COMPONENT
COMPONENT S-VIDEO
FRONT AND REAR PANEL DESCRIPTIONS
PASS THROUGH
COMPOSITE
OFF:
11-10
A
B
PWR
C
D
M
I
E
1 2
4 5
7 8
OFF
0
ON
R
UNCO
1. Composite Video Source Selection
2. S-Video Source Selection
3. Component Video Source Selection
4. Not used
5. Pass-Through
6. Not used
7. Anamorphic Aspect Ratio Selection
8. 4:3 Aspect Ratio Selection
9. Letterbox Aspect Ratio Selection
ON: Discreet ON Command
Discreet OFF Command
G
F
H
3
J
6
9