Quick Menu - Runco Reflection DR-300c Owner's Operating Manual

Quick Menu

The 'Quick Menu' allows you to position and blank any signal sent through the RGB/Component input.
This can be done without having to go through the standard menu, as the Quick Menu is done com-
pletely from the front panel.
The Quick Menu is only available when you are in the RGB/Component source, and the instal-
lation mode is active (pg. 21).
To use the quick menu, press ENTER on the front panel, and observe the front panel display. The fol-
lowing will be displayed:
The first mode of the Quick Menu is SHIFTING. When this is displayed, press the up, down, left or
right arrows to shift the image. For all of the adjustments, the quick menu will time-out 10 seconds
from the last button press, so ensure that you make the adjustments within that time.
If you do not need to make any position adjustments or you have completed making them, press
ENTER again to display the next mode of the shift menu, which is for TOP BLANKING:
To adjust top blanking, press the up or down arrow buttons. Once the adjustments have been com-
pleted, or no adjustment was needed, press ENTER. The final mode of the quick menu will be dis-
played, which is for BOTTOM BLANKING:
To adjust bottom blanking, press the up or down arrow buttons. Once the adjustments have been
completed, or no adjustment was needed, press ENTER. You will then exit the quick menu. If you
need to re-adjust or touch up any of the three adjustments, press ENTER again to re-enter the quick
menu.
Quick Menu: Shifting
Press arrows or enter...
Quick Menu: Top Blanking
Press arrows or enter...
Quick Menu: Bottom Blanking
Press arrows or enter...
24