Table of Contents
Advertisement
[Wiring/Connection Precautions]
● When disconnecting the communication and power supply cables from the
module, do not hold and pull the cable part.
Disconnect the cables after loosening the screws in the portions connected
to the module. Pulling the cables connected to the module can damage the
module and cables or can cause a malfunction due to a cable connection
fault.
[Startup and Maintenance Precautions]
● Do not touch the terminals without having the power supply shut down
externally at all phases. Doing so may result in malfunctions.
● Do not disassemble or modify the modules.
Doing so could cause failure, malfunction, injury or fire.
● Do not drop the module or give it hard impact since its case is made of resin.
Doing so can damage the module.
● Make sure to switch all phases of the external power supply off before
cleaning.
If you do not switch off the external power supply, it will cause failure or
malfunction.
● Make sure to switch all phases of the external power supply off before
mounting or removing the module. If you do not switch off the external power
supply, it will cause failure or malfunction of the module.
● Before performing a test operation, set slow speed for the speed limit
parameter value, and prepare to stop immediately in case any dangerous
conditions occur.
● Do not install/remove the terminal block more than 50 times after the first use
of the product. (IEC 61131-2 compliant)
● Before handling the module, always touch grounded metal, etc. to discharge
static electricity from the human body.
Failure to do so can cause the module to fail or malfunction.
[Disposal Precautions]
● When disposing of this product, treat it as industrial waste.
CAUTION
CAUTION
CAUTION
A-4
Advertisement
Table of Contents
