Runco PlasmaWall PL-61CX Owner's Operating Manual page 29

TINT (also known as 'hue') is essentially the ratio of red to green in the color portion of the image.
If TINT is decreased, the image will appear redder, and increasing it will cause the image to appear green-
er. To set TINT properly, look at the color bar pattern through a blue filter. Adjust TINT until the middle two
tall color bars match the middle short color bars (see color bar drawing).
COLOR (also known as 'saturation') increases or decreases the amount of color in the image.
To set COLOR properly, look at the color bar pattern through a blue filter. Adjust COLOR until the outer two
tall color bars match the outer short color bars (see color bar drawing).
For setting CONTRAST and BRIGHTNESS, please refer to the PLUGE pattern below:
Below black
Above black
CONTRAST adjusts the white level of the image. Adjust contrast until there is a distinct definition between
the two brightest bars.
NOTE: For best results, Runco recommends that CONTRAST be set to 'midrange' or very close to it.
BRIGHTNESS adjusts the black level of the image. To adjust this properly, adjust BRIGHTNESS until the
'below black' bar JUST disappears, but the 'above black' bar is still barely visible.
NOTE: Some DVD players cannot pass the 'blacker than black' bar (they won't pass PLUGE), and that bar
will never be visible. In a case like this, adjust the 'above black' bar until it is slightly brighter than the back-
ground that surrounds it.
Set contrast
until there is
no 'blooming'
in this bar.
19