Rear Panel - Runco PlasmaWall PL-61CX Owner's Operating Manual

Rear Panel

1
COMLINK OUT
12V FUSE
RS-232 IN
MASK SCREEN
12V TRIGGER
2 3 4
1. 12v FUSE
This fuse protects the 12v outputs from the MASK and SCREEN jacks.
(Screen Fuse: 5mm x 25mm, AGC, 0.5A, 250V, Fast Blow)
2. MASK
This is a 12V output that can be used to trigger curtains, lifts, etc. (1/4A maximum load).
3. SCREEN
This is a 12V output that can be used to trigger curatins, lifts, etc. (1/4A maximum load).
4. RS-232 IN
This is for systems using serial (RS-232) to control the PFP Controller.
5. COMLINK OUT
The output of this jack must be connected to the ComLink input of the PL-61cx Plasma monitor.
If this is not connected, neither the Controller or the Plasma can operate.
6. RGB OUTPUT
This is the RGB output of the PFP Controller. Connect the RGB output of the Controller to the PL-61cx's RGB BNC
port.
7. HDTV/PROGRESSIVE DVD
This is the input for HDTV or progressive DVD sources.
If the signal is RGB, select 'RGB HD'; if it is Component, select 'Component HD'.
8. COMPONENT INPUT
This is the input for Component Video from sources such as DVD players.
Note: The component output from a DTV decoder or a progressive-scan DVD cannot be used with this port;
it must be used with the HDTV port.
9. S-VIDEO INPUT
This is the input for S-Video from sources such as Satellite receivers, S-VHS VCR's and DVD players.
10. COMPOSITE VIDEO INPUT
This is the input for Composite Video from sources such as laser disc players, VCRs and other misc. sources.
11. POWER INPUT
Plug in Main Power here.
12. 115 VAC FUSE
This is the main AC Input fuse (.5A/250V).
13. MAIN POWER SWITCH
Disconnects or applies main power to the Controller.
5
RGB OUTPUT
V H B G R
6
VIDEO INPUTS
HDTV Y Pr Pb S-VIDEO COMPOSITE
7 8 9 10
14
CAUTION
! RUNCO INTERNATIONAL
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AC 120V 60Hz, 15W
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
MADE IN USA
11 12
UNION CITY, CA
MADE IN USA
13