Installation - iGenix IG9901 User Manual

INSTALLATION

Warning: Leave the unit to stand for 12 hours before connecting to the mains electricity supply after
transport or when it has been tilted (e.g. cleaning), to allow the coolant gases time to settle.
Unpacking
• Open the box and remove all of the packaging and the exhaust assembly
• Grip the unit by the carry handles located on either side and carefully lift until it slides out
of the foam base
• Install the exhaust hose assembly onto the unit before switching on
Installing Exhaust Hose
Extend the exhaust hose by pulling out the two ends of the hose
Screw the exhaust hose into the exhaust hose connector, turning anti-clockwise
Screw the other end of the exhaust hose onto the exhaust hose adaptor
Slide the exhaust hose assembly into the exhaust duct located on the back of the unit. Ensuring the
connector has clicked into place
6