Table of Contents
Advertisement
5.0 Electrical Connectors and Pin Descriptions
The DSL+PLM connector and Ethernet (SFP) port are located at the front edge of the card. The Ethernet, serial
data and power interface is via the 96-pin DIN 41612 connector on the back edge. To interface directly to the
DSL daughter card (bypassing the PLM daughter card) contact the factory.
When installing mating connectors to the 4 pin connectors (for DSL+PLM) on the front edge, both mounting
screws need to be tightened simultaneously to prevent side loading and possible damage to the connectors.
Ref
J3, DAUGHTER CARD
J3, CARRIER CARD
J11, CARRIER CARD
5.1 Carrier Card with Daughter Cards
DAUGHTER CARD
Figure 5-1: Carrier Card with Daughter Cards (Front View)
Focal Technologies Corporation
A Moog Inc. Company
Table 5-1: Connector/Mating Connector Part Numbers
Description
4 –PIN DATAMATE J-TEK
CONNECTOR
4 –PIN DATAMATE J-TEK
CONNECTOR
96 PIN DIN41612
CONNECTOR
FACE VIEW
Table 5-2: 4-Pin DSL + PLM Connector Pin-out
Connector
Pin Number
1
2
3
4
Manufacturer
Manufacturer
Part Number
HARWIN
M80-5400442
HARWIN
M80-5400442
HARTING
0903-196-6921
PLM CONNECTOR
(DSL+PLM FUNCTION)
J3
J3
FACTORY USE ONLY
2
1
3
4
DSL+PLM Connector
Daughter Card 1
J3, DSL+PLM
TIP_PLM1
RING_PLM1
CHASSIS
CHASSIS
Model 922-DSLH – User Manual
Mating Manufacturer
Part Number
M80-4610405
M80-4610405
0903-296-6824
Document No. 922-0677-00, Rev 1.0
Page 5-1
Advertisement
Table of Contents
