Kohler Command Pro EFI ECH940 Service Manual page 99

Install #2 Valley Baffl e
Install cylinder #2 valley baffl e with two screws and
torque screws to 2.5 N·m (22 in. lb.) into new holes, or
2.0 N·m (18 in. lb.) into used holes.
Install #1 Valley Baffl e
1. Install 1 screw to secure cylinder #1 valley baffl e to
backing shroud. Torque screw to 2.5 N·m (22 in. lb.)
into new hole, or 2.0 N·m (18 in. lb.) into used hole.
2. Install fuse holder bracket over baffl e and secure
with 2 screws. Torque screws to 10.7 N·m (95 in. lb.)
into new holes, or 7.3 N·m (65 in. lb.) into used
holes.
3. Secure dipstick tube to fuse holder bracket. Once
positioned, slide down spring hose clamp to secure.
4. If equipped, install fuses into fuse covers on fuse
holder bracket.
5. Insert clips into baffl e to secure wire harness.
6. Push connector on engine temperature sensor
making sure a good connection is made and click is
heard. Secure lock tab.
Install Throttle Body
NOTE: Ensure all parts are clean, undamaged and free
of debris and make sure electrical connector has
seal in place.
1. Install a new throttle body O-ring prior to installation.
2. Install throttle body and throttle linkage.
3. Install vent hose assembly to throttle body.
4. Push electrical connector onto throttle position
sensor (TPS) making sure a good connection is
made.
62 690 13 Rev. A
Install Governor Lever
Install governor lever onto governor shaft and connect
throttle linkage with black linkage bushing and
dampening spring. Do not tighten governor lever at this
time.
Install Temperature/Manifold Absolute Pressure
(TMAP) Sensor
NOTE: Ensure all parts are clean, undamaged and free
of debris and make sure electrical connector has
seal in place.
1. Lightly oil TMAP sensor O-ring and push sensor into
bore in intake manifold.
2. Torque screw to 7.3 N·m (65 in. lb.).
3. Push electrical connector on TMAP sensor making
sure a good connection is made. Slide down lock
tab.
Install Fuel Lines to Fuel Pump
1. Reinstall low pressure fuel line to fuel pump. Slide
clamp to secure in place.
2. Install fuel line into clips and secure to valley baffl e.
KohlerEngines.com
Reassembly
99