Kohler Command Pro EFI ECH940 Service Manual page 101

Install and Adjust Governor Lever
Details
B
D
A Governor Lever
Governed Idle
C
Spring
1. Position governor lever so clamping area is inboard
but completely on knurled area of governor cross
shaft.
2. Move governor lever toward throttle body as far as it
will go (wide-open throttle) and hold in position.
3. Insert a long thin rod or tool into hole on cross shaft
and rotate shaft clockwise (viewed from end) as far
as it will turn, then torque nut to 7.1 N·m (63 in. lb.).
4. Connect governor spring (with long looped end), to
inner hole on governor lever and control bracket.
5. Connect governed idle spring to outer governor lever
hole and control bracket. Make sure springs do not
contact valley baffl e.
62 690 13 Rev. A
C
A
B Governor Spring
D Cross Shaft
KohlerEngines.com
Install Oil Sentry (if equipped)
™
1. Apply pipe sealant with Tefl on
Thread Sealant or equivalent) to Oil Sentry
switch and install it into 1/8 in. port in closure plate.
Torque switch to 10.7 N·m (95 in. lb.).
2. Connect green wire lead to Oil Sentry
Install Oil Cooler
1. Connect hoses between oil fi lter adapter and oil
cooler. Secure with new clamps in same orientation
as noted in Disassembly.
2. Align oil cooler with bosses in backing shroud
assembly. Secure with screws and washers. Torque
screws to 2.3 N·m (21 in. lb.)
Install Blower Housing and Cylinder Shrouds
1. Align and install blower housing.
2. Secure blower housing with screws. Torque screws
to 2.5 N·m (22 in. lb.) into new holes, or 2.0 N·m
(18 in. lb.) into used holes.
3. Install cylinder shrouds and secure with shoulder
screws. Torque screws to 2.5 N·m (22 in. lb.) into
new holes, or 2.0 N·m (18 in. lb.) into used holes.
Install Electric Starter Motor
1. Install electric starter motor using screws.
2. Torque screws to 16.0 N·m (142 in. lb.).
3. Connect leads to solenoid.
Reassembly
(Loctite PST 592™
® ® ®
threads
™
terminal.
™
101