Kohler Command Pro EFI ECH940 Service Manual page 102

Reassembly
Control Panel Components
A Control Panel
E Washer
I Ground Terminal
Install Control Panel (if equipped)
1. If key switch was removed, install in control panel aligning slot in key switch housing with tab on control panel.
Secure key switch with washer and nut on outside of control panel. Torque nut to 1.6 N·m (14 in. lb.).
2. Connect ground terminal and 5-pin connector to key switch.
3. Connect yellow, tan, and green wires for Oil Pressure and MIL LEDs. Ensure yellow wires are connected to
positive (red mark) indicator light terminals.
4. Slide control panel up and over oil fi lter housing.
5. Install control panel to main control bracket and oil fi lter housing. Torque top 2 screws into intake manifold to
11.3 N·m (100 in. lb.). Torque bottom screw into oil fi lter housing to 11.3 N·m (100 in. lb.).
Install Muffl er
1. Install new exhaust gaskets onto exhaust studs.
2. Install port liners (if equipped). Attach muffl er and secure with nuts onto exhaust studs. Torque nuts to 24.4 N·m
(216 in. lb.).
3. If equipped, install any attaching hardware and brackets. Torque M6 screws to 9.9 N·m (88 in. lb.), and M8 screws
to 24.4 N·m (216 in. lb.).
4. Install oxygen sensor, torque to 50.1 N·m (37 ft. lb.), and connect to wire harness.
5. Install spark arrestor (if used).
102
J
J
A
B MIL Indicator Light
Indicator Positive
F
(Red Mark) Terminal
J Yellow Wire
KohlerEngines.com
L
K
I
F
H
G
Oil Pressure
C
Indicator Light
G Key Switch
K Tan Wire
A
C
B
F
E
D
D Nut
H 5-Pin Connector
L Green Wire
62 690 13 Rev. A