Kohler Command Pro EFI ECH940 Service Manual page 16

Specifi cations
TORQUE SPECIFICATIONS
Fuse Holder Bracket
Fuse Holder Bracket to Cylinder Head Fastener
Governor
Governor Lever Nut
Governor Yoke Mounting Screw
Ignition
Ignition Coil Fastener
Electronic Control Unit Isolation Mount Nut
Crankshaft Position Sensor to Bracket Screw
Crankshaft Position Sensor Bracket to Crankcase Screw
Spark Plug
Rectifi er-Regulator Fastener
Rectifi er-Regulator Ground Lead Fastener to Ground Lug/Backing
Shroud
Wire Harness Clamp and Ground Eyelets Fastener
Intake Manifold (torque sequence on page 14)
Intake Manifold to Cylinder Head Mounting Fastener
(torque in 2 increments)
Temperature/Manifold Absolute Pressure (TMAP) Sensor Fastener
Air Cleaner to Throttle Body Fastener Nut
Air Cleaner to Control Bracket Fastener
Fuel Injector Cap Fastener
Lifter Feed Chamber
Cover Screw
Muffl er
Oxygen Sensor
Retaining Nut
M6 Screw
M8 Screw
Oil Cooler
Mounting Screws
Oil Filter Housing Assembly
Housing Assembly Mounting Screw
Oil Filter Nipple
Oil Pickup Screen
Mounting Screw
Oil Pickup Tube
Mounting Screw
2 Values are in Metric units. Values in parentheses are English equivalents.
Lubricate threads with engine oil prior to assembly.
5
16
2,5
KohlerEngines.com
ECH940 ECH980
10.7 N·m (95 in. lb.) into new holes
7.3 N·m (65 in. lb.) into used holes
7.1 N·m (63 in. lb.)
2.2 N·m (20 in. lb.)
5.1 N·m (45 in. lb.)
2.0 N·m (18 in. lb.)
11.3 N·m (100 in. lb.)
9.9 N·m (88 in. lb.)
27 N·m (20 ft. lb.)
2.5 N·m (22 in. lb.)
5.6 N·m (50 in. lb.) into new holes
4.0 N·m (35 in. lb.) into used holes
2.5 N·m (22 in. lb.) into new holes
2.0 N·m (18 in. lb.) into used holes
fi rst to 16.9 N·m (150 in. lb.)
fi nally to 22.6 N·m (200 in. lb.)
7.3 N·m (65 in. lb.)
8.2 N·m (73 in. lb.)
11.3 N·m (100 in. lb.)
7.3 N·m (65 in. lb.)
7.7 N·m (68 in. lb.)
50.1 N·m (37 ft. lb.)
24.4 N·m (216 in. lb.)
9.9 N·m (88 in. lb.)
24.4 N·m (216 in. lb.)
2.3 N·m (21 in. lb.)
23.7 N·m (210 in. lb.)
17.8 N·m (158 in. lb.)
9.3 N·m (82 in. lb.) into new holes
7.7 N·m (68 in. lb.) into used holes
11.3 N·m (100 in. lb.) into new holes
7.7 N·m (68 in. lb.) into used holes
62 690 13 Rev. A