Kohler Command Pro EFI ECH940 Service Manual page 95

6. Install a plain washers on each of screws. Apply
Loctite 242 to screw threads.
® ®
7. Carefully remove studs and replace with screws.
Torque screws to 9.9 N·m (88 in. lb.). Repeat
procedure for other studs and screws.
Install Debris Screen and Fan Option #2
Failure to utilize or reassemble debris screen
as designed could result in debris screen
failure and serious personal injury.
Debris Screen and Fan Components
A Fan
Fan Mounting Holes Detail
A Fan Mounting Holes
62 690 13 Rev. A
CAUTION
A
B
B Debris Screen
B
A
B Fan Locator Holes
KohlerEngines.com
NOTE: Use this reassembly sequence if fan and debris
screen were kept as a complete assembly and
not replaced individually.
1. Inspect fl ywheel position on engine. Note two fan
pilot hole locations on face of fl ywheel.
Pilot holes accept two locator pins which are molded
into mating surface of engine cooling fan.
2. Using two hands, pick up fan, screen, and hardware
as a complete assembly (as described in
Disassembly section).
3. Arrange assembly vertically to position fan mating
surface against fl ywheel fan mounting surface.
4. Turn fan/screen assembly. Pay close attention to
locator pins on fan and ensure that they mate to
locator holes on face of fl ywheel.
5. While holding fan/screen assembly in position
against fl ywheel, start fan/screen mounting screws
into fl ywheel.
6. Screw all four screws fi nger tight making sure fan
locator pins are aligning with locator holes in
fl ywheel. Torque screws to 9.9 N·m (88 in. lb.).
Reassembly
95