Kohler Command Pro EFI ECH940 Service Manual page 69

Remove Intake Manifold/Injectors/Fuel Rail/FPM
Assembly
1. Carefully remove clip from #2 barrel baffl e.
2. Remove screws securing intake manifold to cylinder
heads.
3. Remove screws securing FPM to baffl e.
4, Remove screws securing FPM baffl e to crankcase
and remove baffl e.
3. While holding FPM so fuel does not leak out, remove
intake manifold assembly and intake manifold
gaskets. Note position of gaskets for reassembly.
Remove Crankshaft Position Sensor
NOTE: Do not remove sensor from bracket unless
sensor is being replaced.
1. Remove screws securing crankshaft position sensor
bracket to crankcase posts.
2. Disconnect electrical connector from crankshaft
position sensor.
Remove Oil Filter Housing
Oil Filter Housing Components
G
I
K
A Oil Filter Nipple
Oil Filter Valve
C
Spring
E Oil Filter Valve
62 690 13 Rev. A
A
B
D
C
E
F
H
L
J
B Oil Filter Cup
D Oil Filter Cup Spring
F Oil Filter Housing
KohlerEngines.com
Disassembly/Inspection and Service
G Screw
I Pipe Plug
K O-Ring
NOTE: Further disassembly of oil fi lter housing
assembly is not required unless being serviced
individually. Follow substeps a, b, c and d.
1. Remove screw securing oil fi lter housing and
individual O-rings to crankcase. Carefully separate
parts.
Perform following only if oil fi lter housing assembly
requires individual servicing.
a. Remove nipple from cup and oil fi lter housing.
b. Remove oil fi lter cup and spring from housing.
c. Remove rubber valve and spring from cup.
d. If oil passages in housing require cleaning,
remove pipe plug, barbed fi tting, and O-rings.
Remove Debris Screen and Fan Option #1
G
F
E
D
A Screw
C Debris Screen
E Spacer
G Fan
NOTE: Use this disassembly sequence if fan and debris
screen are being repaired/replaced individually.
NOTE: Inspect fan/screen assembly for cracks, nicks, or
damage of any kind. Replace fan and/or screen
if any damage is found.
1. Remove screws and washers securing screen.
2. Remove screen, support ring, and spacers, paying
attention to curvature of spring washers between
spacers and fan.
H Straight Fitting
J Barbed Fitting
L Dowel
C
B
C
B Washer
D Support Ring
F Spring Washer
A
69