Samsung SCX-6320F/XEC Service Manual page 93

6.7 Machine Error Codes (Service codes)
6.7.1 Machine Error Message
Error Message
DOCUMENT JAM
DOOR OPEN
BYPASS JAM
DUPLEX JAM
Drum Warning
Function Full
PAPER JAMØ
PAPER JAM1
Open/Close Door
PAPER JAM 2
Check Inside
NO PAPER ADD
PAPER
LSU ERROR
LOW HEAT ERROR
OPEN HEAT ERROR
Samsung Electronics
Description
The loaded document has jammed in the
DADF
The side cover is not securely latched.
The machine detected a mis-feed from the
BYPASS Tray.
The machine detected a duplex jam in the
middle of 2-sided printing.
The drum cartridge is near the end of its
life.
The memory is full.
Recording paper is jammed in the paper
feeding area.( Recording paper is jammed
in pick-up unit)
The machine has detected a paper jam in
fuser area. OPEN the side door and clear
the jam. CLOSE the door to continue.
The machine has detected a paper jam in
paper exit area. OPEN the side door and
clear the jam. CLOSE the door to continue.
The recording paper has run out. The
printer system stops.
The Laser Scanning Unit did not reach the
READY state within a defined time or a
problem has occurred in the LSU.
The Fuser temperature did not reach a
certain level, or the thermister has become
disconnected.
During operation the fuser temperature
fails to rise correctly, the Thermister is not
connected to the main board or contact
points are loose or dirty.
Solution
Clear the document jam.
Close the cover until it locks into place.
Open the side Cover and remove the
jammed paper.Load paper in the bypass tray.
Remove the jammed paper
You should ensure a replacement
cartridge is in stock.
Either delete unnecessary documents, or
retransmit after more memory becomes
available. The transmission can also be
split into more than one operation if it is a
large job.
Press STOP and remove the jammed
paper
Remove the jammed paper
Remove the jammed paper
Load the recording paper in the paper
feeder.
Try Power Off-Power On.
*Please test the LSU in engine test mode.
*If the problem still persists, replace the
LSU unit.
Try Power Off-Power On.
*Check thermister contact point & heat roller.
*If the problem still persists, replace fuser
unit.
*Check thermister contact point and cable
connection.
*Please test the fuser in engine test mode.
*If the problem still persists, replace fuser unit.
Alignment & Adjustments
DADF
Feeder
Feeder
Feeder
Feeder
Feeder
Feeder
Feeder
LSU
Fuser
Fuser
Service Manual
6-23