Fax Features; Scan Speed - Samsung SCX-6320F/XEC Service Manual

Summary of Product

4.4 FAX FEATURES

4.4.1 ITU-G3 Compatibility
The SCX-6320F is compatible with G3 communication mode, and is not compatible with G1 and G2.
ITU-T: The International Telecommunications Union, a committee created to set international standards for
telecommunications.
4.4.2 Scan Width and Resolution
The SCX-6320F utilizes a scan width of 216mm Max., 208mm effective and provides optical 600dpi-scan
resolution. In the Fax mode, 203x98dpi (Normal), 203x196dpi (Fine), 300x300dpi (Superfine), 203x392dpi, and
406 x 392 dpi (super fine) resolutions are supported. When storing the scanned image data into memory for
transmission, if the Superfine resolution mode is selected this will be changed to Fine resolution automatically as
the set cannot determine, before contact is established, if the remote machine has the capability to support
Superfine resolution, i.e. the Superfine resolution is supported only for direct transmission.
In the Scanner mode, 75dpi through 600dpi resolutions are supported optically and higher resolutions up to
4800dpi can be supported by interpolating via the bundled Twain driver.

4.4.3 Scan Speed

Scan speed indicates the speed at which a machine scans a page and is normally expressed in 1.4sec per page
with Standard resolution from a document in the DADF. The SCX-6320F is capable of scanning a page for
transmission in just 3 seconds (based on ITU-T No.1 Chart, MMR compress).
4.4.4 Automatic Reduction when Receiving Data
When receiving a document that is as long as or longer than the paper installed in the product, the SCX-6320F
can reduce the data in the document to fit the recording paper size set by the end-user. The machine can reduce
the incoming data in vertical and horizontal direction. Otherwise, the incoming page may need to be divided into
two pages with only a few centimeters on the second page. The few centimeters on the second page can be dis-
carded by setting end-user options. (Discard size options) If the supplied paper is not matched with the paper size
set by the end-user, the reduced and printed image data may not be printed correctly. In order to support
Automatic reduction operation, the memory has to have a capability to receive a one-page image data completely.
Sometimes if the image data is bigger than the memory capacity, for example, full image with Superfine Photo res-
olution, the image cannot be received.
Service Manual
4-20
Samsung Electronics