Table of Contents
Advertisement
The amplifier
The CVR-100 + MKII is equipped with a high-quality AB class amplifier with an output of 2 x 60 watts to 4 ohms
(RMS).
To change the sound, use the following settings:
Volume:
Use „VOL +" and „VOL-" buttons on the remote control (see pg. 10 / items 16 and 17) or the multi-function knob
(page 9 / item 7) on the device to change the volume of your system overall.
Please note that for different signal sources, the volume of the CVR-100 + MKII can vary with the volume setting.
This is not a defect but it is caused by different input levels of the connected signal sources.
Balance:
Use the keys „L" and „R" on the remote control (page 10 / item 14 and 15) to change the balance between the
two speakers and move to centralise the sound in the room.
Bass:
To raise or lower the bass, press „Tone" on the remote control (see page 10 / item 24) until „Bass" appears on
the display. Use the „VOL +" and „VOL-" buttons on the remote control (page 10 / items 16 and 17). This function
deactivates after a short time
Volume:
Press „Tone" on the remote control (see page 10 / item 24) so often, until „Treble" appears in the display. Now
press the „VOL +" and „VOL-" buttons on the remote control (page 10 / items 16 and 17) to increase or decrease
the volume. This function deactivates itself after a short time.
DSP-setting (Digital Sound Processing):
Press the „SUR" button (see page 10 / item 25)
This key, is used to switch on various digital sound enhancements such as „Normal", "Live", „Jazz", „Rock",
„Hall", „Classic", „Pop" and „Stadium", press several times to view the different modes. Try to find out which
setting suits you best, on the „Normal" mode this function is deactivated.
15
Advertisement
Table of Contents
