Table of Contents
Advertisement
First commissioning and installation
After you have safely installed your device and have carried out all the wirings, you can switch on your CVR-100
+ MKII for the first time (page 9 / item 15). Please hold your password (WEP or WPA) and, if necessary, your
network identifier (SSID) ready for a possible WLAN installation. After turning on, the CVR-100 + MKII will start
on CD mode.
▶
Please, confirm the question after starting the equipment assistant wizard with "Yes", press the arrows
keys of the remote control until "Yes" lights up and confirm with the key "Enter"
▶
Select your desired time format, either 12 h or 24 h display and confirm with the key „Enter".
▶
Select in the next step „Update from DAB" (recommended) and confirm.
▶
Every time it starts, your CVR-100 + MKII, will in future recover automatically from this source the informa-
tion to time and datum.
▶
For the following time zone setting, please select for Germany UTC +1: 00. For other locations, please select
the appropriate time zone and confirm.
▶
In the following setting, please indicate whether your location currently has summer time, then „ON"
would be the correct input
▶
In the following query „Keep network connected?", it should be confirmed with „Yes" in order to avoid
interception and streaming problems.
▶
When choosing WLAN region, please choose "Most of Europe".
▶
Now it starts searching a WLAN connection and shows you all found WLAN networks (SSID) in your sur-
rounding. Select your WLAN network. In case your WLAN does not appear, this could be due to the fol-
lowing reasons:
WLAN aerial not installed.
WLAN signal too weak at the installation place (perhaps it would be necessary to adjust the aerial to
the router and on the CVR-100 + MKII or use a WLAN repeater).
WLAN SSID suppressed on the router, select the input "Manual configuration" (see page 14).
If you connect the CVR-100 + MKII with an ethernet cable with your router, instead of using WLAN,
select "Cable" (see page 14).
▶
In case your router supports WPS, select "Press key" and then press the appropriated button on the router.
Alternatively you can also choose "skip WPS" and subsequently enter the network password (WEP or WPA).
Afterwards, in both cases the device should be finally connected.
13
Advertisement
Table of Contents
